-40%

Five- or Six-Tube Zenith Tuner Support item: t14

$ 1.05

Availability: 51 in stock
  • Item must be returned within: 14 Days
  • Refund will be given as: Money Back
  • Restocking Fee: No
  • Return shipping will be paid by: Buyer
  • All returns accepted: Returns Accepted
  • Condition: New

    Description

    Used on the tuner section of some 5-tube radios. Replacing the tuner grommets on these radios will allow the dial to be centered in the cabinet opening. Zenith used a cupped steel fender washer 3/4" OD top and bottom on this tuner with the rubber bushing in between of course. Stuffed into the rubber bushing is a bakelite spacer. It is 1/4" OD and a bit over 1/4" long. After installation, you tighten down the three nuts from below until the rubber is compressed to match the Bakelite tubes in the middle of the rubber bushing. Used on models: Zenith 5S127 (chassis 5516), 5A127 (chassis 5517A and 5525A), 6S229 (chassis 5638) and other probably other similar models. Dimensions: Slightly over 3/4” diameter, 1/2" tall, 1/4” hole, 7/32” section on top and bottom, fits a 1/2” chassis hole
    PRICE IS FOR ONE.
    Used on the tuner section of some 5-tube radios. Replacing the tuner grommets on these radios will allow the dial to be centered in the cabinet opening.
    Zenith used a cupped steel fender washer 3/4" OD top and bottom on this tuner with the rubber bushing in between of course. Stuffed into the rubber bushing is a bakelite spacer. It is 1/4" OD and a bit over 1/4" long. After installation, you tighten down the three nuts from below until the rubber is compressed to match the Bakelite tubes in the middle of the rubber bushing.
    Used on models: Zenith 5S127 (chassis 5516), 5A127 (chassis 5517A and 5525A), 6S229 (chassis 5638) and other probably other similar models. Dimensions: Slightly over 3/4” diameter, 1/2" tall, 1/4” hole, 7/32” section on top and bottom, fits a 1/2” chassis hole
    :
    Attention Sellers - Get Templates
    Image Hosting, Scheduling at Auctiva.com.